200L Barrel Semi-Automatic Resin Liquid Filling Machine

Equipment Overview:

This machine is specially designed for 100-300kg resin liquid drum packaging and intelligent packaging system, easy to use and adjust, strong control ability. It has the characteristics of easy operation, high production efficiency and wide application range. Suitable for the packaging of resins of various viscosity levels, as well as raw materials and auxiliaries of intermediate chemical products. It has stable production capacity, simple operation, high production capacity, and is the ideal equipment for large, Sinopec and intermediate enterprises.

The machine uses the working principle of weighing to realize the control of filling quantity. The material flows into the container by itself (or is fed by the pump) to be loaded.

The filling department of this machine realizes fast filling and slow filling through thick and thin double pipes, and the filling flow rate is adjustable. At the beginning of filling, both pipes are opened at the same time. After filling to the fast filling set amount, the thick pipe is closed, and the thin pipe continues to fill slowly until the set overall filling amount is reached. All valves and interfaces are sealed with polytetrafluoroethylene or silicone rubber.

Automatic peeling and filling according to net weight;

It is provided with a liquid receiving tank and automatically protrudes after filling to prevent the material from dripping on the surface of the barrel. The oil in the barrel shall not splash outside during the conveying and capping process before the barrel is sealed. The mouth and body of the barrel are free from oil pollution after the barrel is sealed.

Prevent misoperation, failure and other emergency processing functions;

The control system has manual and automatic functions;

Filling quantity real-time display function;

Anti-indoor pollution design, including filling machine centralized exhaust, filling machine floor oil leakage, etc.;

The flange standard is SH/T3406-2013;

The protection level of the instrument is not less than IP65, the electrical protection level is not less than IP54, and the photoelectric switch is equipped with a metal shield;

The conveying roller table adopts carbon steel plated Cr, and the height difference between it and the ground is the minimum number.

Electrical and mechanical systems have overload protection devices. The design and installation of the electrical system comply with the relevant provisions of the state electrical safety;

There are foreseeable safety system and other system failures displayed on the touch screen or with alarm devices;

Installation, repair, maintenance process with false start prevention device;

Man-machine interface set hierarchical management mode;

Failure should be displayed on the control panel, with sound and light alarm.

All design, manufacturing, installation and commissioning must meet the relevant national safety requirements, standards and regulations.

The equipment must be equipped with an emergency stopping device if the following conditions exist:

When danger occurs, it cannot quickly stop the operation of the equipment through the control switch to terminate the danger;

Can not be through a master switch, quickly interrupt a number of dangerous motion units;

Other hazards may arise as a result of cutting off a unit.

Main technical parameters: